If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You must be an NCRS member
before you can post: click the Join NCRS link above to join. To start viewing messages,
select the forum that you want to visit from the selection below.
I am in the process of rebuilding the rear suspension and noticed that the radius rod frame bracket holes are egg shaped from the previous drag racing owner. The original radius rods were replaced with a piece of square stock measuring 21"x2"x1" and they weigh about 25# each. I have new brackets to weld on and the original rods but I am curious as to how exact these brackets need to be. Also, what should I use as the best reference points to align the new brackets. I want to be as exact as possible before cutting the old ones off. Thanks. Gary
We use cookies to deliver our services, and to analyze site activity. We do not share or sell any personal information about our users. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
Tweet