If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You must be an NCRS member
before you can post: click the Join NCRS link above to join. To start viewing messages,
select the forum that you want to visit from the selection below.
I used studs to align everything and then pulled each stud and replaced with a bolt. This would have the mount down on the bolts on both sides when I tightened them. If I understand John's logic, the passenger side would be correct but the drivers side should be lifted so it is against the bottom of the bolts. My leaks are always on the drivers side, so, if the drivers side is moving up, Johns logic is supported. Plus, the holes are out of round on the pass side and ok on drivers side, so further support. It's already together and I'm just waiting the 24 hours. If it leaks again, I'll try it.
LP
We use cookies to deliver our services, and to analyze site activity. We do not share or sell any personal information about our users. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
Tweet