C1 (60) heater air flow?

[Jim K.]

My thanks to everyone, my fan motor works. I connected a ground to the heater fan motor and it works.
Question: How much air should be flowing out? Mine doesn't appear to be pushing that much? I know it's pushing and not pulling the air( smoke test)!!

[William C.]

Re: C1 (60) heater air flow?

What speed? At low speed, not much comes out, on high blower the difference is significant.

[Jim K.]

Re: C1 (60) heater air flow?

Bill, there is a difference on the high setting in that the fan motor sounds like it's turn faster, but the flow (air output) is not that much more.

[Jim K.]

Re: C1 (60) heater air flow?

I have another ? and that is where does the hose cramp (water pump & manifold hoses) on the generator bracket get bolted down to. I tried using the tension bolt but the bracket sticks up too high and the hood won't close? Should it be located lower on the generator backet?

[John H.]

Re: C1 (60) heater air flow?

Jim -

The Assembly Manual illustration shows the clamp under the forward bolt that attches the U-bracket to the exhaust manifold, angled down and inboard.

[Dennis C.]

Jim... On your heater fan air flow...

...make sure you have the fresh air inlet fully open.