If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You must be an NCRS member
before you can post: click the Join NCRS link above to join. To start viewing messages,
select the forum that you want to visit from the selection below.
Houston I think we have a problem. I went to install the pilot busing in the end of the crankshaft and it slid in with no interference. The pilot bushing measures 1.095" but the hole appears to be approximately 1.117". I used a socket to approximate it since the calipers wouldn't reach. Are there any solutions short of replacing the crank?
We use cookies to deliver our services, and to analyze site activity. We do not share or sell any personal information about our users. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
Tweet