If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You must be an NCRS member
before you can post: click the Join NCRS link above to join. To start viewing messages,
select the forum that you want to visit from the selection below.
The ST-12 states that replacement of the lower control arm shaft bushings (inner) may be accomplished without removal of the lower control arm and without replacing the shaft. Just unscrew one end at a time and replace.
What about the lower outer (pivot bushings), upper inner, and upper outer ones? Is it necessary to remove the spring, control arms, and shafts to replace the bushings on those 3 places?
We use cookies to deliver our services, and to analyze site activity. We do not share or sell any personal information about our users. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
Tweet