Tri Carb Mounting - NCRS Discussion Boards

Tri Carb Mounting

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Lynn S.
    Expired
    • November 1, 2004
    • 99

    Tri Carb Mounting

    Tri carb system is for 69 L89 car. Alum manifold is clean and all three carbs replated/built. The center carb needed a new base plate as the original had one corner broken. Front and rear carbs set flat on manifold but the center carb seems to have a little wobble corner to corner. I do not want to tighten it down and break the base plate. Can I use 2-3 gaskets? Would you put any sealer between the carb, gasket, manifold. Thanks
  • Kevin M.
    Expired
    • November 1, 2000
    • 1271

    #2
    Re: Tri Carb Mounting

    Both of those fixes are going to cause problems, better get to the bottom of the wobble.

    Kevin

    Comment

    Working...

    Debug Information

    Searching...Please wait.
    An unexpected error was returned: 'Your submission could not be processed because you have logged in since the previous page was loaded.

    Please push the back button and reload the previous window.'
    An unexpected error was returned: 'Your submission could not be processed because the token has expired.

    Please push the back button and reload the previous window.'
    An internal error has occurred and the module cannot be displayed.
    There are no results that meet this criteria.
    Search Result for "|||"