I need some help with the size of the metal vacuum tube that runs down the passenger side of the carb on a 1972 with a 454 in it.
I have had no luck finding one, so I thought I might try to make my own.
I need the dimensions and location of the little flanges, plus the overall length of the tube.
The inside diameter and outside diameter would help quite a bit too.
I have a pretty good idea on how to make the little bubble style flanges, but I have not made the tools I think I need yet.
If you have done this or have any ideas on how to do it, I am open for suggestions.
I can make whatever tools we might need, I just need to know what to make.
Thanks guys. I could not have built this car without your help.
M
I have had no luck finding one, so I thought I might try to make my own.
I need the dimensions and location of the little flanges, plus the overall length of the tube.
The inside diameter and outside diameter would help quite a bit too.
I have a pretty good idea on how to make the little bubble style flanges, but I have not made the tools I think I need yet.
If you have done this or have any ideas on how to do it, I am open for suggestions.
I can make whatever tools we might need, I just need to know what to make.
Thanks guys. I could not have built this car without your help.
M