Tweet
looking through the ass/man , it stated that the lower cupped washer is to face inboard. It seems the washer should cradle the rubber grommet,similar to a stabilizer washer. Am i correct? an example would be nut, special cupped washer , radius towards the rubber{ as shown .
2ND ? is there a lockwasher to be used.
The way the manual states it sounds as if the washer radius should be placed the opposite way around }then rubber
sounds like a simplton ? but correct knowledge has me wondering which way is correct.
2ND ? is there a lockwasher to be used.
The way the manual states it sounds as if the washer radius should be placed the opposite way around }then rubber
sounds like a simplton ? but correct knowledge has me wondering which way is correct.
Comment