If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You must be an NCRS member
before you can post: click the Join NCRS link above to join. To start viewing messages,
select the forum that you want to visit from the selection below.
I'm restoring a 69 vette and have replaced the rear wirring harness with a new unit from Eagle Wire. How do you attach the fiber optic ends to the fiber optic lens ? The ends have little brass ends but they don't fit in the holes? Anyone have a solution or am I missing something?
Thanx Mark
The brass ferrules on the end of the fiber optic cables should lightly "snap" into the orifice in the bottom of the fiber optic lens. If they don't, then I would expect that either the lense orifices are worn or the ferrules used on the reproduction cables are the wrong size. You can use black electrical tape to secure the cable ends to the rear of the lenses. Of course, if the ferrules are too large to fit into the lense orifices, I don't know what you could do.
We use cookies to deliver our services, and to analyze site activity. We do not share or sell any personal information about our users. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
Tweet
Comment