Tweet
Trying to locate the proper tie rod ends for my 62. Mary Jo, Kanter, Paragon all have the grease fittings exiting near the threaded ends versus at a right angle to it. Any help in locating a proper banding kit/material for the rear springs and exhaust system hangers that would pass flight judging critera would be appreciated. Thanks in advance.
-
-
Re: 62 Restoration questions
I guess we need to define a little better the proper location of the grease fitting in an OEM location. The correct orientation is on a plane aligned horizontal to the ground through the centerline of the shaft with the grease fitting at about a 45 degree angle to the shaft. that sounds a lot like what you are describing as available from Mary Jo and others. Sounds correct per your description.Bill Clupper #618 -
Re: 62 Restoration questions
Thanks Bill, all this time I was led to believe that the proper original location was at a right angle to the shaft.Comment
-
Re: 62 Restoration questions
I buy many parts from Chevy organizations because many parts are original to Corvette. Try them for C1's
www.nationalchevyassoc.comComment
Comment