55 Master Cylinder rebuild - NCRS Discussion Boards

55 Master Cylinder rebuild

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Keith Tholin

    55 Master Cylinder rebuild

    I need to rebuild my master cylinder and have just purchased a rebuild kit. Any special advice for this? Does the cylinder need to be honed?

    Thanks.
  • Craig S.
    Extremely Frequent Poster
    • June 30, 1997
    • 2471

    #2
    Re: 55 Master Cylinder rebuild

    My guess is a hone would be the absolute minimum required, the bore needs to be free of pits or corrosion. I sent my master cylinder to Apple Hydraulics and had them brass sleeve it, they did great! You can then rebuild it yourself....cost is about $60. You can get a complete rebuild through them for $175-195 or so, White Post Restorations also does excellent work, but they will not just sleeve, they only perform the complete rebuild, their cost is $150. Both are online, http://www.applehydraulics.com or http://www.whitepost.com Good luck!....Craig

    Comment

    • roy braatz

      #3
      Re: 55 Master Cylinder rebuild

      Try honeing it first, then install the kit and try it, then if not good send it out.

      Comment

      Working...

      Debug Information

      Searching...Please wait.
      An unexpected error was returned: 'Your submission could not be processed because you have logged in since the previous page was loaded.

      Please push the back button and reload the previous window.'
      An unexpected error was returned: 'Your submission could not be processed because the token has expired.

      Please push the back button and reload the previous window.'
      An internal error has occurred and the module cannot be displayed.
      There are no results that meet this criteria.
      Search Result for "|||"