If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You must be an NCRS member
before you can post: click the Join NCRS link above to join. To start viewing messages,
select the forum that you want to visit from the selection below.
These will be a little tough to come by. As far as I know they are not reproduced. There are any number of vendors who will likely have a complete restored assy in stock, but I suspect it will be pricey. Check with Mary Jo Rohner and Chicago Corvette. They are both pretty apt to have pieces like this, but hang on to your wallet if they do. Might also check with Cranes.
Richard,
Ed gives good advice, shenever I exhausted my normal sources, ebay,CC, and Zip Products. I went to mary jo and she always had what I needed. But due to her prices it was usuall the last place I went. I completed my 57 two years ago so I haven't done business since then. Ph 858-451-1933 or her website is "vettegal.com" Tell her Larry from Tennessee sent you!
BTW, you asked about dimensions to make some parts. If you get to that point, I'll be glad to get you some measurements, but IMHO, unless you have some very fancy metal forming equipment these parts would be very, very tough to make.
If all else fails, try calling "Patty" at Corvette Central (800.345.4122). For $154.00 + s/h they will send you a completely refurbished dash insert assembly, including the upper and lower stainless steel trim. I'm about to do the same on my '59. Good luck.
We use cookies to deliver our services, and to analyze site activity. We do not share or sell any personal information about our users. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
Tweet
Comment