62 posi rear - NCRS Discussion Boards

62 posi rear

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Robert M.
    Expired
    • April 30, 1999
    • 415

    62 posi rear

    My 62 327/340 currently has a 3.70 open rear in it. I recently bought a new correct dated 3.70 posi. I noticed that I don't have the threaded hole in the axle housing to accept the elbow for the vent pipe assembly. Is this just a matter of drilling and tapping the housing for the elbow and vent line?
  • Mike M.
    NCRS Past President
    • May 31, 1974
    • 8365

    #2
    Re: 62 posi rear

    just drill and tap and your new posi will be properly vented.mike

    Comment

    • Gary Chesnut

      #3
      Re: 62 posi rear

      Might also need to cut 1/8 inch off of each of the axles or they could possibly bind the posi unit. Good luck, Gary#5895

      Comment

      Working...

      Debug Information

      Searching...Please wait.
      An unexpected error was returned: 'Your submission could not be processed because you have logged in since the previous page was loaded.

      Please push the back button and reload the previous window.'
      An unexpected error was returned: 'Your submission could not be processed because the token has expired.

      Please push the back button and reload the previous window.'
      An internal error has occurred and the module cannot be displayed.
      There are no results that meet this criteria.
      Search Result for "|||"