C2 rear spring _ dead horse

[Steve D.]

In light of recen posts on the subject, I'm sorry for flogging the horse, but I want to make sure I understand.

The instructions in my 63 shop manual (section 4-8)for installation of the rear spring are 1) place spring on carrier cover mounting surface..... 2) place center clamp plate in position, install bolts, torque to 55-75 lb. ft. 3) raise spring outer end with floor jack......

Does this procedure risk breaking the ears off of the differential cover?

Steve

[Wayne W.]

Re: C2 rear spring _ dead horse

Yes. Do not tighten the bracket bolts until the outer bolts are installed.

[Steve D.]

Thanks *NM*