If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You must be an NCRS member
before you can post: click the Join NCRS link above to join. To start viewing messages,
select the forum that you want to visit from the selection below.
Bought a pair of trans shaft plastic covers. They are black plastic and per the 66 judging naunal they were on one or both sides on mid to late 66's. Can't figure out how to install them since the end of the knurled shaft dia. is bigger than the cover end. Looks like the plastic may need to be slit or forced over the knurled end? Any ideas? I'm certainly not going to disassemble the wiper trans. to install these things.
Dave, I installed a new pair on my 66 and they install fine. I soaked them in some warm water to soften them a bit and they slid and stretched over the ends. After they are on they will tighten up fine. No special cutting needed.
We use cookies to deliver our services, and to analyze site activity. We do not share or sell any personal information about our users. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
Tweet
Comment