Hello:
The replacement Engine Starting Procedure label Part # 345532 I purchased from Rik's Unlimited measures 4 1/16" X 7 1/8". My Al Knoch sunsade measures approx. 4 1/4" X 11" at the top and 10" at the bottom. There is an approx. 1/4" binding along the bottom edge on the shade. If label is mounted above the binding the top of the label wrapes over the top of the shade. This doesn't seem right and I doubt if it would stay glued. I think the label may not be trimmed properly. Does anyone know the correct overall dimensions of the label. The other possibility is that the sunshade is too small. Any thoughts?
Thanks, Bill
The replacement Engine Starting Procedure label Part # 345532 I purchased from Rik's Unlimited measures 4 1/16" X 7 1/8". My Al Knoch sunsade measures approx. 4 1/4" X 11" at the top and 10" at the bottom. There is an approx. 1/4" binding along the bottom edge on the shade. If label is mounted above the binding the top of the label wrapes over the top of the shade. This doesn't seem right and I doubt if it would stay glued. I think the label may not be trimmed properly. Does anyone know the correct overall dimensions of the label. The other possibility is that the sunshade is too small. Any thoughts?
Thanks, Bill
Comment