'57 Exhaust (2x4 Engine)

[Bob A.]

I would like to replace the complete exhaust system on a '57 with the 2x4 engine. What would you suggest be used, and where would you purchace the system? Thanks in advance for your suggestions, they are appreciated.

Best Wishes!

Bob Adams

[Steve Junkersfeld]

Re: '57 Exhaust (2x4 Engine)

Bob,

When I replaced the exhaust system on my 56 2X4, I used a Zip, aluminized steel, system. The fit and quality were just fine. I opted not to use stainless because of originality and I figured that as much as I would drive the 56, it would still last forever. Additionally, I suspect that a lot of the different repo systems are manufactured by the same exhaust bender, so you're probably safe with any reputable Corvette supplier. Good luck, Steve

[James F.]

Re: '57 Exhaust (2x4 Engine)

Steve,
You have mail. Regards,

[Art B.]

Re: '57 Exhaust (2x4 Engine)

Bob:
I replaced the exhaust system in my '57 two years ago. I purchased it from Corvette Central. The pipes and mufflers fit together nice and I had to do only one or two cuts with the hacksaw on the tailpipes.

[Allen W.]

Re: '57 Exhaust (2x4 Engine)

Would anyone like to comment on the use and sound of the round mufflers versus the oval ones?
Allen

[John H.]

Re: '57 Exhaust (2x4 Engine)

Allen -

The round mufflers are "straight-through", and are both louder and have a nice "rrrrap" tone; great sound! Mix with the singing of solid lifters, and that's a recipe you can't forget

[Art B.]

Re: '57 Exhaust (2x4 Engine)

When I bought my '57 it had oval mufflers, the generic kind the muffler shops put on. I installed a complete system including the round "off road" mufflers from Corvette Central. The sound was louder, but not irritating, even with the top down. I like the result.