Torque for spindle & flange nuts - NCRS Discussion Boards

Torque for spindle & flange nuts

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Jeff A.
    Expired
    • December 1, 2001
    • 95

    Torque for spindle & flange nuts

    This should be an easy one, although I can't find it in the AIM. What torque should go on the spindle nut (rear) and on the flange bolts holding the half shafts on ? Thanks and happy holidays.
  • Joe C.
    Expired
    • August 31, 1999
    • 4598

    #2
    Re: Torque for spindle & flange nuts

    Spindle nut: 100 ft-lbs. Do not loosen--go to next castellation if necessary.

    Flange bolts: 40 ft-lbs

    Comment

    • Joe L.
      Beyond Control Poster
      • February 1, 1988
      • 43193

      #3
      Re: Torque for spindle & flange nuts

      Joe and Jeff-----

      The flange bolts (i.e. the bolts that retain the half shaft u-joint flange to the spindle flange) are torqued at 75 ft/lbs.
      In Appreciation of John Hinckley

      Comment

      Working...

      Debug Information

      Searching...Please wait.
      An unexpected error was returned: 'Your submission could not be processed because you have logged in since the previous page was loaded.

      Please push the back button and reload the previous window.'
      An unexpected error was returned: 'Your submission could not be processed because the token has expired.

      Please push the back button and reload the previous window.'
      An internal error has occurred and the module cannot be displayed.
      There are no results that meet this criteria.
      Search Result for "|||"