If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You must be an NCRS member
before you can post: click the Join NCRS link above to join. To start viewing messages,
select the forum that you want to visit from the selection below.
I have aquired 3 P-02 hubcaps, trying to make a set for my 1970. Does anyone know the correct black paint to be used when refinishing the caps? It appears to be a semi gloss or satin black, however the juding manual says little regarding this option. Also, what is the best way to mask off the outer rim of the cap to be painted? Any ideas/suggestions would be appreciated.
I used the semi flat paint available in most corvette parts catalogs, I used the same tape that you can buy at an auto parts store to pin stripe a car. I dont remember the size buy you should have no trouble figuiring it out. I cut a bunch of strips and overlapped them at the top and bottom of the cap. They came out perfect
I used the semi flat paint available in most corvette parts catalogs, I used the same tape that you can buy at an auto parts store to pin stripe a car. I dont remember the size buy you should have no trouble figuiring it out. I cut a bunch of strips and overlapped them at the top and bottom of the cap. They came out perfect
We use cookies to deliver our services, and to analyze site activity. We do not share or sell any personal information about our users. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
Tweet
Comment