pitman/third arm ball wear - NCRS Discussion Boards

pitman/third arm ball wear

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Chris H.
    Very Frequent User
    • April 30, 1990
    • 817

    pitman/third arm ball wear

    Where can I find allowable wear on the ball? Not in service guides that I can find.

    Pitman ball has an oval delta of .016", Third arm is .034". I did find one mention in the archives that .075 was too much.

    Thanks
  • Roy B.
    Expired
    • February 1, 1975
    • 7044

    #2
    Re: pitman/third arm ball wear

    The wear is OK check the ball cups for wear and replace them (same as any early car) Some one may have tightened the adjustment to much or didn't grease them often.

    Comment

    Working...

    Debug Information

    Searching...Please wait.
    An unexpected error was returned: 'Your submission could not be processed because you have logged in since the previous page was loaded.

    Please push the back button and reload the previous window.'
    An unexpected error was returned: 'Your submission could not be processed because the token has expired.

    Please push the back button and reload the previous window.'
    An internal error has occurred and the module cannot be displayed.
    There are no results that meet this criteria.
    Search Result for "|||"