C-3 Door Ajar re-visited - NCRS Discussion Boards

C-3 Door Ajar re-visited

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Tony Roussos

    C-3 Door Ajar re-visited

    I suppose if I were ever asked for advice in troubleshooting, I would now say something like never assume anything and never rule out the obvious.

    My door ajar warning light wouldn't come on but very intermittantly for either door. I presumed it was a faulty ground that affected both door switches. For some reason, I ruled out the likelyhood that both switches were bad. They were both bad. I ordered replacements from Ecklers. One of theirs was bad too. The spring broke through the center of the body before I got a chance to screw it back in the door jamb.

    I haven't tried to check the factory alarm yet, but I will give the door ajar contact a closer look before I chase my tail again for something more technical.

    I hope my experience helps another restorer somewhere, sometime.

    Tony
  • Harmon C.
    Extremely Frequent Poster
    • August 31, 1994
    • 3228

    #2
    Re: C-3 Door Ajar re-visited

    Tony On the alarm start with the key switch and test on the back side with a meter to see if it works then the horn as they are the most common areas I have found to need work on the system after the switches which you have repaired. Lyle
    Lyle

    Comment

    • Harmon C.
      Extremely Frequent Poster
      • August 31, 1994
      • 3228

      #3
      Re: C-3 Door Ajar re-visited

      Tony On the alarm start with the key switch and test on the back side with a meter to see if it works then the horn as they are the most common areas I have found to need work on the system after the switches which you have repaired. Lyle
      Lyle

      Comment

      • Klaus Friedrich #33362

        #4
        Re: C-3 Door Ajar re-visited

        Tony,

        I've got the same problem with my 69. Don't use the original switches - they are a misconstruction! Use the second generation (76 ->). They got better contacts and are working really fine since a year.

        Klaus

        Comment

        • Klaus Friedrich #33362

          #5
          Re: C-3 Door Ajar re-visited

          Tony,

          I've got the same problem with my 69. Don't use the original switches - they are a misconstruction! Use the second generation (76 ->). They got better contacts and are working really fine since a year.

          Klaus

          Comment

          • Tony Roussos

            #6
            Re: C-3 Door Ajar re-visited

            I was wondering if I could do that! I ordered the exact replacements from Ecklers. One broke! The retract spring breached the body, so they're sending a new one. I'll follow your advice the next time I replace these switches. Thank you.

            Tony

            Comment

            • Tony Roussos

              #7
              Re: C-3 Door Ajar re-visited

              I was wondering if I could do that! I ordered the exact replacements from Ecklers. One broke! The retract spring breached the body, so they're sending a new one. I'll follow your advice the next time I replace these switches. Thank you.

              Tony

              Comment

              Working...

              Debug Information

              Searching...Please wait.
              An unexpected error was returned: 'Your submission could not be processed because you have logged in since the previous page was loaded.

              Please push the back button and reload the previous window.'
              An unexpected error was returned: 'Your submission could not be processed because the token has expired.

              Please push the back button and reload the previous window.'
              An internal error has occurred and the module cannot be displayed.
              There are no results that meet this criteria.
              Search Result for "|||"