If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You must be an NCRS member
before you can post: click the Join NCRS link above to join. To start viewing messages,
select the forum that you want to visit from the selection below.
Trying to determine what correct water neck would be for a very late 57/270. I have seen aluminum 223's both with and without the depressions around the stud holes on several cars but have also seen cast iron without the depression( part nbr unknown)on several. I need to find a proper neck but do not know what to look for. I really could use some guidance on this. Thanks.
Joe,
On a late '57, 2 X 4 manifold, I would expect to see an aluminun thermostat housing, embossed # 3837223, without the depressions on either side of the stud holes. Regards,
We use cookies to deliver our services, and to analyze site activity. We do not share or sell any personal information about our users. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
Tweet
Comment