If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You must be an NCRS member
before you can post: click the Join NCRS link above to join. To start viewing messages,
select the forum that you want to visit from the selection below.
'66 Judging Guide calls for .25" hex-head screws to mount to the brackets (under car exhaust). Is this correct, or should they be pan-head Phillips? According to the '65 - '67 AIM, the GM part number was the same (9421851), and I believe pan-heads are correct for a '67.
Carl, This has been a question in my mind for some time. I personally believe it is the pan head phillips. When I had my 66 judged I never seemed to have the correct screws. Pan heads, which seemed to be original, came off my 67. At this point if someone out there has a Bowtie 66 it would be interesting to hear from them.
Carl/Mark - Pan head phillips w/ floating washer for '66. That's what came on my '66 and that's what's going back on the car. BTW, I believe the TIM&JG is incorrect on the rocker panel molding screw configuration; except for those car on which they were changed to conform to the manual. Pete
We use cookies to deliver our services, and to analyze site activity. We do not share or sell any personal information about our users. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
Tweet
Comment