Frame stencil for 1960 Corvette - NCRS Discussion Boards

Frame stencil for 1960 Corvette

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Edwin S.
    Expired
    • June 30, 2000
    • 2

    Frame stencil for 1960 Corvette

    I have received a stencil for the frame of my 1960 Corvette from Quanta, but the location instructions are vegue. Their location, on Technical Bulletin #2, for a 1953-1962 reads as follows "The frame stencil is generally upside down on the drivers side slightly rear or front of center." All of the information in the Corvette Chassis Restoration Guide refers to a location from the 3/4" hole and/or the edge of the frame. There is a picture of a 1960, unrestored, which does not show the 3/4" hole at all. I sure would like to locate it properly. Thanks!
  • Jerry C.
    Very Frequent User
    • November 1, 1995
    • 741

    #2
    Frame Stencil

    JG says Upsidedown below drivers seat. Just center it from top to botom and don't stencil over any holes. Don't forget to roll it on as was done at factory.

    Comment

    Working...

    Debug Information

    Searching...Please wait.
    An unexpected error was returned: 'Your submission could not be processed because you have logged in since the previous page was loaded.

    Please push the back button and reload the previous window.'
    An unexpected error was returned: 'Your submission could not be processed because the token has expired.

    Please push the back button and reload the previous window.'
    An internal error has occurred and the module cannot be displayed.
    There are no results that meet this criteria.
    Search Result for "|||"