If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You must be an NCRS member
before you can post: click the Join NCRS link above to join. To start viewing messages,
select the forum that you want to visit from the selection below.
I am installing a new ignition harness in my 62 (with a fusible link) and am having some trouble in routing the harnesss under the dash. The AIM shows some J-clips that retain the harness to the underside of the dash which my car does not have. Where are these clips supposed to be mounted exactly? I have some studs that protude from a metal cross-car brace to which the hinge asm for the cowl vent mounts. I suspect that J-clips attach to these studs. Also, how is the ignition harness supposed to be routed relative to the cowl vent handle/lever asm?
6 clips are attached to the windshield mounting bolts, these clips locate the harness across the under side of the dash. The 2 front braces have one clip each. The main harness routing will be will above the cowel lever. One break out for the courtesy light , radio, & heater will be forward of the cowel lever however. Be sure and get this break out at the proper place, for the wires will be short if you do not. On a '61, the Tach cable, antenna cable & wiper hose runs across in the same clips.
We use cookies to deliver our services, and to analyze site activity. We do not share or sell any personal information about our users. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
Tweet
Comment