If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You must be an NCRS member
before you can post: click the Join NCRS link above to join. To start viewing messages,
select the forum that you want to visit from the selection below.
Hi All, I have finally changed my old core support. Now that I have everything lined up the headlight motor support arms don't want to fit. Is there a trick to this? Or should I loosen up the core support and try to line them up first?
Thanks!
As a general rule, you don't want to tighten up any of the fastners of a related system until all the fastners have been first installed loosely. If you were working on a Swiss watch, the space shuttle or, possibly, something like a Rolls-Royce, you might not have to do this. However, when you're working on an older Corvette, it's a good idea. It can save a lot of frustration.
We use cookies to deliver our services, and to analyze site activity. We do not share or sell any personal information about our users. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
Tweet
Comment