If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You must be an NCRS member
before you can post: click the Join NCRS link above to join. To start viewing messages,
select the forum that you want to visit from the selection below.
Can the plastic line be removed/replaced WITHOUT removing the sending unit ??
I removed the small 'cap/nut' put the line doesn't seem to want to come out.
There is NO sending unit for oil pressure on C3 Corvettes which are equipped with a pressure line. The piece that you are probably referring to is simply a fitting and, as Dick mentioned, you don't need to remove it to remove the line. You do, of course, need to remove the tubing nut from the fitting.
Oil pressure sending units for C3 Corvettes did not begin until the 1974 model year. Then, a wire connected the the sending unit to the gauge and no pressure line was used.
We use cookies to deliver our services, and to analyze site activity. We do not share or sell any personal information about our users. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
Tweet
Comment