If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You must be an NCRS member
before you can post: click the Join NCRS link above to join. To start viewing messages,
select the forum that you want to visit from the selection below.
Would someone be able to e-mail me a clear, overhead pic of the "PG" that is stamped on their master cylinder? My pad is very badly rusted and it is almost impossible to make out the "PG" so I would like to try and clean up the pad a bit and then stamp over this code to bring it back out. I found a place that might be able to supply this type of character so I want to make sure that it is bang on if I go this route. Thanks.
We use cookies to deliver our services, and to analyze site activity. We do not share or sell any personal information about our users. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
Tweet
Comment