If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You must be an NCRS member
before you can post: click the Join NCRS link above to join. To start viewing messages,
select the forum that you want to visit from the selection below.
Rebuilding my headlight motors and found some serious bubba engineering. On one motor, the case was drilled through and a quarter inch bolt used to hold the stator to the inside of the case. The bolt protruded from the case by about 5/8” because a washer and nut was used for spacing I suppose.
If I send this motor to someone for rebuild I assume they will consider this a nonrebuildable core. What are my options? Can I buy just the case?
We use cookies to deliver our services, and to analyze site activity. We do not share or sell any personal information about our users. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
Tweet
Comment