If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You must be an NCRS member
before you can post: click the Join NCRS link above to join. To start viewing messages,
select the forum that you want to visit from the selection below.
I am trying to determine the correct size screw to use on my '61 windshield frame. There are two unfilled holes on each side of the frame on either side of the alignment pin receiver casting. The frame is countersunk for each screw in the stainless trim, but there does not appear to be threads (perhaps these were lost during rechroming). The closest tap size is 12-24 which a nearly extinct screw thread.
Can anyone provide help with the particulars for the correct screws?
We use cookies to deliver our services, and to analyze site activity. We do not share or sell any personal information about our users. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
Tweet
Comment