If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You must be an NCRS member
before you can post: click the Join NCRS link above to join. To start viewing messages,
select the forum that you want to visit from the selection below.
getting ready to pull inside heater box but cannot get small round clip off
bowden cable, the clips that hold the cable on. I am also having trouble getting the engine compartment side of, seems really well sealed. any ideas? the project so far has been pretty simple, easy going.
To replace the heater core, you really do not need to pull the firewall side of the heater box. You only need to take the bolts off the firewall side. If you want to pull the firewall side, try adding heat to the sealed edges with a heat gun. Be careful not to overheat. As for removing the cable clips on the inside, try loosening the clip with a small flat screwdriver. Then use a small pair of needle nose wrapped in cloth to lift the clip.
We use cookies to deliver our services, and to analyze site activity. We do not share or sell any personal information about our users. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
Tweet
Comment