If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You must be an NCRS member
before you can post: click the Join NCRS link above to join. To start viewing messages,
select the forum that you want to visit from the selection below.
I am ready to attempt to install the carpeting in my 65 conv. with an Al Knoch carpet set. Is there a good detailed set of instructions anywhere that I might get to help me with this project? I am a first timer at this and want to do it right. Any help is appreciated. Thanks.
On the seats, remove the seat brackets from the bottom the seats and use them as a template for cutting the bolt hole locations for the seats. Also, be careful of how much you cut around the center console area. That is where I had a slight overcut when I did mine. Use a heat gun to warm the carpet up to make it lay flatter. Measure 10 times, cut once!! Good luck.
the bottom of the carpet to remove any residual plasticizer that'll prevent glue/adhesive from sticking the carpet to the underlying jute. Also, laying the carpet flat and letting the sun 'cook' the wrinkles from pack out of it helps too...
We use cookies to deliver our services, and to analyze site activity. We do not share or sell any personal information about our users. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
Tweet
Comment