Tweet
2 are for the air cleaner and are 1 1/16" and the other are for the heater hoses, 1 1/16" and 1 3/16". I appreciate any thoughts/suggestions.
-
-
Re: For Lyndon Sharpton-71 tower clamps
you might check with Paragon, I know they have the tower clamps. they all might not have dates on them. I know some of the clamps have dates. you might even talk to them about some NOS are used clamps that have the dates that you are looking for. do you have a catalog from them, you might also check CC are corvette central. good luck with the hut, some times thats the most fun! -
Re: For Lyndon Sharpton-71 tower clamps
Melissa,
what car do you have? BB SB LS6 LT-1 ect..Comment
-
Re: For Lyndon Sharpton-71 tower clamps
Make sure they are the correct width also. Some as I recall were 1/2 inch wide and some are 3/8 inch wide. So, you could have the correct size but not the correct width. I ran into this when trying to find some clamps for a smog pump. For my application the smog clamps were to be 1 1/16 by 3/8. I ordered some from two vendors for the same application. One sent me the wide clamps. DR Rebuild sent me the correct stuff. They seem to take pride in having the right stuff down to the small details. Paragon sent me the wrong stuff (interestingly enough). Paragon used to have the details but they are slowly/slid towards the run of the mill catalog companies. Just my observations for the last 15 years. Times seem to change. A nice junk yard with a bunch of 60's cars in it is heaven sent when looking for small stuff. Later, TerryComment
Comment