C-1 Dash End Caps

[Jerry Cosler (26941)]

Doing an early 59 with the stainless dash end caps. How does one trim the dash pad so that these look factory as there is a lot of material on the outside side of these caps. A picture would really help. Thanks in advance.

[Tom Bryant (1360)]

Re: C-1 Dash End Caps

Mine is just trimmed along the edge of the end cap. This is the original pad. I can take some better pictures if you can't see the cut well enough on this one. Tom

[Tom Bryant (1360)]

Re: C-1 Dash End Caps

Well, I don't know why the picture didn't load soI'll send you a couple. Check your email.

Tom

[Roy Braatz (182)]

Re: C-1 Dash End Caps

Tom you first have too delete the http:/ at the bottom URL image line then copy your pic. to it. plus you cant have like the wording (cap pic.) it has to be ONE word like cappic. no spaceing.

[Tom Bryant (1360)]

Re: C-1 Dash End Caps

Thanks. I think I see what went wrong. Let's try again.

[Tom Bryant (1360)]

Re: C-1 Dash End Caps

Let's see if I can make it bigger. I don't do this stuff too much and it shows.

[Roy Braatz (182)]

Re: C-1 Dash End Caps

TOM you did it, but to make a pic. bigger open it in paint , make bigger then save and it will post bigger next time.

[Tom Bryant (1360)]

Re: C-1 Dash End Caps

Getting good in my old age Ray. The first time I copied the address to the thumb nail instead of the full size picture.