C2 Hardtop wrenchs - NCRS Discussion Boards

C2 Hardtop wrenchs

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Dave M.
    Expired
    • June 30, 1999
    • 58

    C2 Hardtop wrenchs

    Hi, Are the factory supplied hardtop wrenches on all C2's exactly the same as far as the casting #'s and lettering goes? I have seen a few with the number 7 cast near the end of the shank and also what apeared to be a number 5 on a few. I don't know if any were originals though. Any help would be greatly appreciated as I am trying to locate an original.

    Thanks Again,
    Dave
  • John H.
    Beyond Control Poster
    • December 1, 1997
    • 16513

    #2
    Re: C2 Hardtop wrenchs

    Dave -

    I don't know if these two are originals or not; I've also seen them with "W01416" instead of "W1416", and don't know which one is "correct" or if it was stamped both ways.




    Attached Files

    Comment

    Working...

    Debug Information

    Searching...Please wait.
    An unexpected error was returned: 'Your submission could not be processed because you have logged in since the previous page was loaded.

    Please push the back button and reload the previous window.'
    An unexpected error was returned: 'Your submission could not be processed because the token has expired.

    Please push the back button and reload the previous window.'
    An internal error has occurred and the module cannot be displayed.
    There are no results that meet this criteria.
    Search Result for "|||"