If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You must be an NCRS member
before you can post: click the Join NCRS link above to join. To start viewing messages,
select the forum that you want to visit from the selection below.
I'm replacing the passenger side dash pad on my 63 convertible. I have all the clips out and have removed the two nuts as well. I still can't lift the pad out since I can't get enough clearance for the two bolts to make it out of their holes. I'm doing this with the dash still in the car. Any suggestions appreciated.
Thanks
John
I removed mine with the dash out of the car. However I think it should lift out the way you have it. Did you remove all the clips that are in the radio area?
Thanks I had the glove box frame out but after reading your message I used a little more force and was able to get the treaded studs out of their holes and the pad came right out after that, the new pad went in with no problem.
We use cookies to deliver our services, and to analyze site activity. We do not share or sell any personal information about our users. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
Tweet
Comment