1958 DRILLING INSTRUCTIONS NEEDED - NCRS Discussion Boards

1958 DRILLING INSTRUCTIONS NEEDED

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • TOM HAEUSLER

    1958 DRILLING INSTRUCTIONS NEEDED

    I AM IN THE PROCESS OF FINALLY FINISHING UP MY 58 AFTER 15 YEARS AND NEED SOME HELP WITH THE LOCATION OF HOLES FOR EXTERIOR MIRRORS, TRUNK IRONS, RADIO ANTENNA, ETC. DO DRILLING TEMPLATES EXIST FOR THIS CAR. IF SO WHERE CAN THEY BE OBTAINED. IF ANYONE COULD GIVE ME THESE DIMMENSIONS IT WOULD BE GREATLY APPRECIATED. THANK YOU
  • Mark L.
    Expired
    • January 1, 1996
    • 121

    #2
    Re: 1958 DRILLING INSTRUCTIONS NEEDED

    Tom....

    I'm getting ready to install side stainless and trunk irons on my car too. To my knowledge templates do not exist. While restoring the body I filled all the holes because the car looked like a machine gun had been taken to it. With careful examination I should be able to discern hole locations though. Will be doing the work over the next few weeks, e-mail me offline and maybe we can help each other out. We solid axle guys are getting few and far between. Best Regards from Connecticut.... Mark

    Comment

    Working...

    Debug Information

    Searching...Please wait.
    An unexpected error was returned: 'Your submission could not be processed because you have logged in since the previous page was loaded.

    Please push the back button and reload the previous window.'
    An unexpected error was returned: 'Your submission could not be processed because the token has expired.

    Please push the back button and reload the previous window.'
    An internal error has occurred and the module cannot be displayed.
    There are no results that meet this criteria.
    Search Result for "|||"