71 wiper r/h washer tube?? - NCRS Discussion Boards

71 wiper r/h washer tube??

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • David M.
    Infrequent User
    • November 1, 2005
    • 19

    71 wiper r/h washer tube??

    how does this run on the wiper arm, from the hose to the spray nozzle? thanks, david
    s
  • Lyle24961

    #2
    Re: 71 wiper r/h washer tube??

    Their is a solder joint at the end of the arm and three or four plastic clips.One arm has three clips one has four. E-Mail for more information or help with yor wiper arms.

    Lyle

    Comment

    • Jack H.
      Extremely Frequent Poster
      • April 1, 1990
      • 9906

      #3
      Re: 71 wiper r/h washer tube??

      One side (RH) loops up over the blade while the tube on the opposite side (LH) points down and 'ahead' of the wiper blade. Both reproduction tubes and plastic clips are available from Paragon. Note: both arms and tubes were painted black and I recommend a torch and silver solder to affix the tubes to the U-shaped cradles at the top of the arms...

      Comment

      • Kevin G.
        Extremely Frequent Poster
        • February 1, 2005
        • 1074

        #4
        Re: 71 wiper r/h washer tube??

        Hi David, here is a picture that may help. Kevin.




        Attached Files

        Comment

        • Harmon C.
          Extremely Frequent Poster
          • August 31, 1994
          • 3228

          #5
          Re: 71 wiper r/h washer tube??

          Unless that picture is making the bends in the tube it is a poor example.

          Lyle
          Lyle

          Comment

          • Kevin G.
            Extremely Frequent Poster
            • February 1, 2005
            • 1074

            #6
            Re: 71 wiper r/h washer tube??

            One more picture for you.




            Attached Files

            Comment

            • Harmon C.
              Extremely Frequent Poster
              • August 31, 1994
              • 3228

              #7
              Re: 71 wiper r/h washer tube??

              Much better picture! If I was restoring them I would make the part between the weld and the bend straight and move the top clip away from the other one to a position near the bend.

              JMHO Lyle
              Lyle

              Comment

              Working...

              Debug Information

              Searching...Please wait.
              An unexpected error was returned: 'Your submission could not be processed because you have logged in since the previous page was loaded.

              Please push the back button and reload the previous window.'
              An unexpected error was returned: 'Your submission could not be processed because the token has expired.

              Please push the back button and reload the previous window.'
              An internal error has occurred and the module cannot be displayed.
              There are no results that meet this criteria.
              Search Result for "|||"