66 Restoration Question - NCRS Discussion Boards

66 Restoration Question

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Robert Roach

    66 Restoration Question

    The 66 that I am doing originaly came with TI Ign. At some point in time someone took it out. Trying to go back to the original configuration. The Wiring harness that I bought has two resistor wires in it. Is the coil ballast risistor used in the TI setup? Also the engine wiring harness has two pink wires that would go the the coil in a standard set up. What happens to these two wires in the TI set up? I hope I made sense. Thanks, Robert
  • John H.
    Beyond Control Poster
    • December 1, 1997
    • 16513

    #2
    Re: 66 Restoration Question

    Robert -

    T.I. cars didn't use the separate ballast resistor; the required resistance was in the cloth-covered wires in the T.I. harness. The production engine harness reworks for T.I. are shown in the K-66 section of your Assembly Manual, and there's lots of T.I. information at Dave Fiedler's site, www.tispecialty.com .

    Comment

    Working...

    Debug Information

    Searching...Please wait.
    An unexpected error was returned: 'Your submission could not be processed because you have logged in since the previous page was loaded.

    Please push the back button and reload the previous window.'
    An unexpected error was returned: 'Your submission could not be processed because the token has expired.

    Please push the back button and reload the previous window.'
    An internal error has occurred and the module cannot be displayed.
    There are no results that meet this criteria.
    Search Result for "|||"