If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You must be an NCRS member
before you can post: click the Join NCRS link above to join. To start viewing messages,
select the forum that you want to visit from the selection below.
Does anyone know if there are mulitple vendors for the reproduction C2 power window conduits? I bought a set from one major vendor and the curves are bent too tight and do not fit, therefore I'm trying to find another set that fits.
Hi Scott, I have been through the same thing. I have bought NOS, repops, and used original and they all had the same problem rubbing. I have positioned them everyway in the world and finally had to compromise to get the least rubbing as possible. I have had the doors on and off a dozen times to try and overcome this. I finally setteled with the least rubbing position and installed with small bolts and locknuts rather than the tapping screws and they seem to hold just fine even with the slight rubbing. Good luck with yours!
Thank you for this great insight Mike. I started searching all over for some used ones yesterday with no luck, so I guess I can stop that and just work with these.
We use cookies to deliver our services, and to analyze site activity. We do not share or sell any personal information about our users. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
Tweet
Comment