'64 Carburator BaseMounting Hardware - NCRS Discussion Boards

'64 Carburator BaseMounting Hardware

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Gregory G.
    Very Frequent User
    • July 31, 2001
    • 203

    '64 Carburator BaseMounting Hardware

    The four 1/2 inch nuts holding the base to the manifold studs are they accompanied with flat washers or captured washers,or just a plain nut with no washer?

    Greg
  • Joe L.
    Beyond Control Poster
    • February 1, 1988
    • 43193

    #2
    Re: '64 Carburator BaseMounting Hardware

    Greg-----

    Actually, the nuts are not 1/2" nuts. They're 1/2" ACROSS THE FLATS, but, technically, they are 5/16-24 nuts. Anyway, the nuts were just plain old hex nuts with no washers of any kind. They should have had flat washers, but someone decided that they didn't need any to save a few pennies per car.
    In Appreciation of John Hinckley

    Comment

    Working...

    Debug Information

    Searching...Please wait.
    An unexpected error was returned: 'Your submission could not be processed because you have logged in since the previous page was loaded.

    Please push the back button and reload the previous window.'
    An unexpected error was returned: 'Your submission could not be processed because the token has expired.

    Please push the back button and reload the previous window.'
    An internal error has occurred and the module cannot be displayed.
    There are no results that meet this criteria.
    Search Result for "|||"