If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You must be an NCRS member
before you can post: click the Join NCRS link above to join. To start viewing messages,
select the forum that you want to visit from the selection below.
Just working on the fine details. I am currently restoring the cross shaft assembly on the 65. The correct finishes are listed in the JG for everything except the little C clips. I cleaned up the originals and one appears to be black oxide and the other looks like zinc plate, but it's really hard to tell. What is the correct finish for the fasteners?
We use cookies to deliver our services, and to analyze site activity. We do not share or sell any personal information about our users. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
Tweet
Comment