Tweet
If my 64 A Frame Dust Shield did not need replacing I would never have taken it off. Ordered the repro's, but they are too thin. Note the following thickness;
63-66 pn 3797054 t= .100" (measured my orig 64 one)
67 pn 3908199 t= .100" (measured an early 70's service one, no yel pn on it)
repro t= .075 (measured purchased one)
Does anyone know if anyone is making a correct flap???
Also notice the 63-66 repro has extra cuts which original Mar64 car does not.
Alan
63-66 pn 3797054 t= .100" (measured my orig 64 one)
67 pn 3908199 t= .100" (measured an early 70's service one, no yel pn on it)
repro t= .075 (measured purchased one)
Does anyone know if anyone is making a correct flap???
Also notice the 63-66 repro has extra cuts which original Mar64 car does not.
Alan