c2 TI amp install is the AIM correct on hole locat *NM*

[Phil P.]

[Rob A.]

Re: c2 TI amp install is the AIM correct on hole l

Phil,

I found it to be correct on my '67 big block.

[Loren L.]

What AIM are we talking about? If

it i '65, it is NOT correct for my late car.

[Phil P.]

67 AIM K66 REF A2 page 316

the "existng" hole for locating the drilling of the other three holes,(for amp mount), looks to be the hole for the "harness" clamp for the turn signal harness---if i'm reading the AIM correctly---the AIM shows the stand alone hole,(outboard), to be 1" inboard off of the "exsiting" hole---if this is used the lower outboard portion of the amp. would cover part of the larger hole that the turn signal harness goes through---this has to be something simple that has plum eluded my simple brain---i'm looking at the fiberglass portion of the fender not the metal core support---thanks,phil

[Phil P.]

67 AIM (sorry) *NM*

[Phil P.]

can some one post a picture of a 67 ti amp instal *NM*

[John H.]

Re: 67 AIM K66 REF A2 page 316

Phil -

The "existing hole" is the large hole for the parking lamp harness grommet.

[Phil P.]

thanks john *NM*