If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You must be an NCRS member
before you can post: click the Join NCRS link above to join. To start viewing messages,
select the forum that you want to visit from the selection below.
This may seem like a dumb quetion but, I need to know where the plug wires exit the forward opening of the lower V shielding to the spark plugs? Do they (wires 1-3-2-4) go between the motor mount and block (between upper 2 bolts) or sneak through the smaller but will work Rear. Either coice is possible. With the forward choice, getting the boots under the motor mount is tight on boot but not the wires. The rear choice is tight on the wire, but to change out at a later date would be easier. Simply loosen up the rear mount bolt to loosen up the V shield and slip wires out. How should they run? Thanks DG
The front plug wires go through the motor mounts. They can be difficult to slide in but if you peel back the wire boot it is possible to get them in with out removing the motor mount bolt.
We use cookies to deliver our services, and to analyze site activity. We do not share or sell any personal information about our users. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
Tweet
Comment