If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You must be an NCRS member
before you can post: click the Join NCRS link above to join. To start viewing messages,
select the forum that you want to visit from the selection below.
Hope you can help me with this as I was pretty good at cataloging all of the parts I disassembled except these. As I recall, I think they came off the right side oil pan for the harness or bat cable but I can't remember the exact placement. Any help you can lend would be greatly appreciated.
Paul: These hold your plug wires in place for the "V" shields to fit over them. To figure out which pan bolt to use, hold your V shield in position and the bolt selection is apparent.
We use cookies to deliver our services, and to analyze site activity. We do not share or sell any personal information about our users. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
Tweet
Comment