If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You must be an NCRS member
before you can post: click the Join NCRS link above to join. To start viewing messages,
select the forum that you want to visit from the selection below.
Anyone have a picture of the correct 67 signal switch wiring routing under the dash, and what brace the curved harness connector is supposed to clip to. I have the AIM and it is sure confusing of where and what brace the little clip on the connector clips to.
Jerry Fuccillo
#42179
Jerry Fuccillo
1967 327/300 Convertible since 1968
Jerry, I got gigged on this very item. It took awhile to figure out. Look at UPC 12 B3 Instrument panel wiring in your AIM.
The flat cable comes out of the bottom side of the column, around the right side of the steering column bracket, and over the column to the left side. The clip is placed on the left side of the pedal brace where it is horizontal and at right angles to the firewall; about 2 inches back from the firewall. This brace point is above the column centerline.
Photo looking up at the steering column.....Top of photo is instrument cluster.
We use cookies to deliver our services, and to analyze site activity. We do not share or sell any personal information about our users. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
Tweet
Comment