Recomendation on push rod.... - NCRS Discussion Boards

Recomendation on push rod....

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Terry F.
    Expired
    • September 30, 1992
    • 2061

    Recomendation on push rod....

    Can someone recommend a single piece push rod with molded ends, chomoly steel, .06 or .08 wall thickness for big block. I am looking for ideas is all. Thanks, Terry
  • Joe L.
    Beyond Control Poster
    • February 1, 1988
    • 43193

    #2
    Re: Recomendation on push rod....

    Terry-----

    Comp Cams #7954-16 or Crane #13640-16. These are a complete engine set. Tubing wall thickness is .08". I don't know of a source for every feature you want with .060" wall thickness.
    In Appreciation of John Hinckley

    Comment

    • Terry F.
      Expired
      • September 30, 1992
      • 2061

      #3
      Thank you Joe! *NM*

      Comment

      Working...

      Debug Information

      Searching...Please wait.
      An unexpected error was returned: 'Your submission could not be processed because you have logged in since the previous page was loaded.

      Please push the back button and reload the previous window.'
      An unexpected error was returned: 'Your submission could not be processed because the token has expired.

      Please push the back button and reload the previous window.'
      An internal error has occurred and the module cannot be displayed.
      There are no results that meet this criteria.
      Search Result for "|||"