If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You must be an NCRS member
before you can post: click the Join NCRS link above to join. To start viewing messages,
select the forum that you want to visit from the selection below.
The two front tie rods(left and right)have two grease fittings on each end of each rod.After the two tie rods are installed which direction should each(four)grease fitting face( the front of Corvette or the rear )?
Thanks
Roy,
Thankyou for the photo!
Does the photo mean the two left sided sided grease nipples should face the rear of the Corvette and the two right sided grease nipples should face the front of the Corvette?
Thanks
We use cookies to deliver our services, and to analyze site activity. We do not share or sell any personal information about our users. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
Tweet
Comment