If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You must be an NCRS member
before you can post: click the Join NCRS link above to join. To start viewing messages,
select the forum that you want to visit from the selection below.
Has anyone seen first hand the wheels that Americas Finest Corvettes are selling? The proclaim the wheels to be exactly like the KH wheels and for the amount of money they want for the wheels I was looking for fist hand comments.
I purchased a set of these wheels for 64. The edge of the fins does not have a machined finish but is instead finished in the same light grey finish as the side of the fins and the area between the fins. I don't have an original KH wheel to compare. I have not received the spinners or adapters yet from CA.
I, too, might be interested in purchasing a set of these particular bolt-on wheels for my '64. Seems AFC is the only vendor carrying these 'thin fin' style wheels compared to what other vendors offer.
Recently, at a car show in Capitola, along with other cars in the show there were two C2's parked fairly close to one another - a '64 and '65. .. . Both cars had the factory style KO wheels installed - one with thin fins; the other with apparently aftermarket thicker finned wheels.
After eyeballin' both styles back and forth I came away knowing that I preferred the thinner fin wheels over the thicker style. I felt the thinner fins did visibily look better.
We use cookies to deliver our services, and to analyze site activity. We do not share or sell any personal information about our users. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
Tweet
Comment